Topcom Butler 6040 - Manual (Page 32)

32 Topcom Butler 6040
Topcom Butler 6040
12 Infra red
You can send and receive contact persons (V-cards 2.1 format) to/from another Infrared
device like a mobile phone or to a second handset (See “Copy entry to another handset” in
4 “Phonebook”).
You can also send and receive NSM ring tones (RNG format ).
To receive infrared data you have to activate the intrared:
• Select Menu then scroll to Handset and press OK
• Scroll to Activate IrDA and press OK
The phone will now be able to receive infrared signals for 2 munites. The icon will appear
on the screen to indicate this.
13 Troubleshooting
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the
batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly
connected Check the telephone cord
connection
The line is occupied by
another handset Wait until the other handset
hangs up
The icon flashes Handset out of range Bring the handset closer to
the base
The base has no power
supply Check the mains connection
to the base
The handset is not registered
on the base Register the handset on the
base
Base or handset do not ring The ringing volume is zero or
low Adjust the ringing volume
Tone is good, but there is no
communication The dialling mode is wrong Adjust the dialling mode
(pulse/tone)
Not possible to transfer a call
on PABX The FLASH time is too short Set the unit to Long Flash
time
Telephone does not react to
pressing the keys Manipulation error Remove the batteries and put
them back in place