Toshiba D-RW2SU/D-RW2SC - Manual (Page 25)

25
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
EN
Make one of the following connections, depending on the capabilities of
your existing equipment.
S-VIDEO IN
OUT
S-VIDEO
P B /C B
Y
P R /C R
COMPONENT
VIDEO IN
COMPONENT
VIDEO OUTPUT
Y
P B /C B
P R /C R
ANTENNA AUDIO IN
VIDEO IN
L
R
AUDIO OUT
VIDEO OUT
(L1)
IN
IN
OUT
OUT
S-VIDEO
COMPONENT VIDEO OUTPUT
L
Y
PB/CB
PR/CR
R
COAXIAL
R L
AUDIO OUT
VIDEO OUT
L
R
AUDIO OUT
TV
Basic Audio
Method 1 Method 2
Better picture Best picture
S-VIDEO OUT COMPONENT VIDEO OUT
Audio cable
(supplied)
S-Video cable
(commercially available)
Component Video cable
(commercially available)
This unit
After you have completed the connections
• Switch the input selector on your TV to an appropriate external input channel (usually near channel 0). Press a button on
the TV’s original remote control that selects an external input channel until the DVD recorder’s picture appears. Check
your TV owner’s manual for details.
Notes
• Connect this unit directly to the TV. If the A/V cables are connected to a VCR, pictures may be distorted due to the copy
protection system.
• When Progressive Scan mode is selected, no video signal will be output from the VIDEO OUT or S-VIDEO OUT
jack.
• This unit is compatible with the Progressive Scan System. The feature provides you with the higher definition images
than the traditional output system does. To utilize this feature, you must set Progressive Scan mode to “ON”.
To set progressive scan mode, refer to page 143.