Rolsen RL-37IT40 - Manual (Page 34)

Displayable Monitor
Specification
34
Note:
a. If the set is cold, there may be a small “flicker” when the set
is switched on. This is normal, there is nothing wrong with
the set.
b. If possible, use the VESA 1,024x768@60Hz video
mode to obtain the best image quality for your LCD
monitor. If used to PC vertical frequency 85Hz, some
noise can be seen when PIP is on. In this case, set the
PC vertical frequency to 60Hz. The set has been pre-
adjusted to the mode VESA 1,024x768@60Hz.
c. Some dot defects may appear on the screen, like Red,
Green or Blue spots. However, this will have no impact
or effect on the monitor performance.
d. Do not press the LCD screen with your finger for a long
time as this may produce some temporary distortion
effects on the screen.
e. When the PC screen appears on the set, a message may
appear on the screen, and the message will differ accord-
ing to the Window system version (Win98, 2000). If a
message appears click “Next” until the message finishes.
f. If the message “ Out Of Range ” appears on the screen,
adjust the PC as in the ‘Displayable Monitor Specification’
section.
RGB Mode / DVI Mode
(Synchronization input form : separate)
Resolution
61.5
31.5
37.9
31.5
37.8
37.5
43.2
35.1
37.9
48.0
46.9
53.7
48.4
56.4
60.0
60.0
63.9
75.0
79.9
91.1
47.7
60.1
68.5
49.0
49.0
75.0
49.7
640X350
720X400
640X480
800X600
1024X768
1280X1024
1280X768
1360X768
1366X768
1600X1200
832X624
MODE
DOS
VGA
SVGA
XGA
SXGA
WXGA
UXGA
MAC
Horizontal
Frequency (KHz)
70.0
70.0
85.0
60.0
72.0
75.0
85.0
56.0
60.0
72.0
75.0
85.0
60.0
70.0
75.0
85.0
60.0
70.0
75.0
85.0
60.0
75.0
85.0
60.0
60.0
60.0
75.0
Vertical
Frequency (Hz)