Toshiba W-622 - Manual (Page 19)

19
PLA
YBACK
Adjusting the tracking
When playback starts, the VCR automatically adjusts the tracking for clear pictures and sound
(Digital Auto Tracking).
If the VCR cannot locate the best possible tracking point, hold down one of
CH/TRK to adjust the
tracking manually.
Notes
• During the adjusting, the playback picture and sound may be distorted.
• The digital auto tracking is activated only in the playback mode.
• The noise on the screen may not be completely eliminated depending on the tape used, especially when the
tape was recorded on another VCR.
Basic Playback
1
Load a recorded cassette.
Power is turned on.
If the cassette has no safety tab,
playback starts automatically.
2 Press PLAY to start playback.
3 To stop playback, press STOP.
Rewinding / Fast-forwarding
Press REW or FF in the stop mode.
S S L P
VCR REC L
TIMER
VCR
PLAYBACK
Playback
This section explains the basic playback operation.
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
• Press VCR to set the remote control operating the VCR.
VCR REC L
TIMER
7 8
0 100
9
6 5
2 3
4
1
SLOW PAUSE/STILL
CANCEL
A.SELECT
EJECT
PROG. ENTER
TIMER
TV VOL
CH/TRK
REC SP/SLP
DISPLAY TV/VCR COUNT RESET REMAIN/ COUNTER
I.SELECT
POWER VCR TV
CURSOR
CM SKIP
STOP
PLAY
FF REW
CH/TRK
REW
2
3
FF
1
Press PLAY during playback.
A tape runs at double speed
playback.
Double Speed Playback
To resume normal playback Press PLAY
S-VHS Quasi Playback (SQPB)
• This VCR can also play back at tape which is recorded in S-VHS format.
But the playback pictures does not have the same quality and resolution as the original S-VHS
playback picture.
• This VCR cannot record in S-VHS format.
• SQPB is an abbreviation for S-VHS Quasi Playback.
W-622 Eng(19-23) 2/28/02, 2:57 PM 19