Thermador DW44FI - Manual (Page 11)

10
Figure 26
Unloading Your Dishwasher
Dishware tends to be hot
immediately after washing and drying.
To cool your dishware more quickly,
open the dishwasher door slightly for
a few minutes before unloading.
Always unload the lower rack first
and unload the upper rack last. This
will prevent any residual water on the
upper rack from dripping onto the
dishes in the lower rack, as shown in
Figure 26.
Cycle Completion Signal
This feature is a tone that sounds
when your dishwasher finishes
washing and drying your dishes. You
can either disable the tone, or you can
set it at one of two volumes (the
dishwasher leaves our factory with the
tone set on the lowest volume).
To change the Cycle Completion
Signal Volume:
1. Open the dishwasher door far
enough to expose the control
buttons.
2. Press and hold down the right-
most of the two buttons labelled
“Cancel Drain”, as shown in Figure
34, then press and hold the On/Off
button. When the light on the
“Cancel Drain” button you are
pressing illuminates, and the tone
begins to sound, release both
buttons.
3. Press the “Cancel Drain” button
you previously pressed until the
tone is at the desired volume, or
until it is silent.
4. Press the On/Off Button.
5. Close the dishwasher door. The
Cycle Completion Signal is now
set, and you may wash your dishes
as usual.
The silverware basket(s) can be
easily removed for unloading by
simply lifting it out of the rack.
Rack Features and
Accessories
In addition to the accessories
discussed in this manual, you can find
many more at our website,
www.thermador.com.
Flip Tines
Flip Tines fold down to make loading
the racks easier in some instances.
To operate the Flip Tines, simply
grasp the tines and gently fold them
downward.
Cup Shelves
Grasp the Cup Shelves, as shown in
Figure 27, and fold them down. Place
cups upside-down on the cup shelves.
Rack Attachment
When installed on the back of the
lower rack, as shown in Figure 29, the
Rack Attachment serves a variety of
uses such as holding cups, large
knives, spatulas, or other large
utensils.
Install the Rack Attachment by
gently levering it into position along
the back of the lower rack until it is
held in place as shown by Figure 29
A.
Figure 27
Knife Rack
The Knife Rack, shown in Figure 28,
may be used for a variety of purposes,
but it is primarily designed to hold fine
silverware and cutlery.
The Knife Rack may be removed by
gently pulling it from the two clips that
attach it to the rack.
Figure 28
Figure 29
A
CARE AND
MAINTENANCE
Certain areas of your dishwasher
require occasional maintenance. The
maintenance tasks are easy to do and
will ensure continued superior
performance from your dishwasher.
(Continued on next page)