Toshiba 32C110U - Manual (Page 46)

Chapter 6: Using the TV’s features
46
Setting the sleep timer
You can set the sleep timer to turn off the TV after a
set length of time (maximum of 12 hours).
To set the sleep timer using the remote control:
Press on the remote control to set the length of
time until the TV turns off. Repeatedly press to
increase the time in 10-minute increments, or press
p or q to increase or decrease the time in 10-minute
increments, to a maximum of 12 hours.
To set the sleep timer using the on-screen
menus:
1無
Press and open the Setup menu.
2無
Highlight Sleep Timer and press .
3無
Press the number buttons to enter the length of
time in 10-minute increments.
4無
Press .
Note: When a power failure occurs, the sleep
timer setting may be cleared.
To display the remaining sleep time:
Press .
To cancel the sleep timer:
Press repeatedly or press p or q until it is set to
0 minutes.
Automatic Power Down
The TV will automatically turn itself off (standby)
after 4 hours, if you do not operate the TV either
from the remote control or the TV control panel.
1無
From the Preferences menu, highlight Energy
Saving Settings and press .
2無
Press p or q to select Automatic Power Down.
3無
Press t or u to select On or Off, and press .
Note:
• The Default setting of this feature is off.
• 1 minute before switching to standby, a
warning message will appear.
• When the following features are set, the
feature that is set for the nearest time will
function.
− Automatic Power Down
− Sleep Timer
− No signal auto power off (after 15 minutes
of no signal)
No Signal Power Down
The TV will automatically turn itself off after 15
minutes when no signal is detected.
You can change the setting to Off for the following
purposes:
• Low signal strength of analog channel (no signal
detection.)
• Only Audio L/R is connected to external input to
listen to music through the TV speakers.
1無
From the Preferences menu, highlight Energy
Saving Settings and press .
2無
Press p or q to select No Signal Power Down
and press .
3無
Press p or q to highlight the item you want to
change, and press t or u to select
On or Off.
Note:
• The default setting of this feature is On.
• A warning message will appear 1 minute
before turning off.
(continued)