Caution - all models, Safety – Thermador GGN30 User Manual
Page 5
SAFETY
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
PLEASE READ CAREFULLY
Section One: General Safety Instructions
.
Page 3
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON and there is no electric
power to operate the electronic igniter of the cooktop, turn OFF the gas
control knob and wait 5 minutes
for the gas to dissipate before lighting
the burner manually. On the models with the ExtraLow™ Gas the two
left burners cannot be turned on manually
.
To light the burners, carefully hold a lighted match to the burner ports
and turn the gas control knob to HI. During a power failure you can use
the cooktop burners, but each must be lit with a match.
If the electrical outlet you intend to use does not accept the 3-prong
plug, it is the personal responsibility and obligation of you, the user, to
have it replaced with a properly grounded 3-prong wall receptacle in
accordance with the National Electrical Code and/or applicable local
codes and ordinances, by a qualified electrician.
CAUTION - ALL MODELS
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE
THIRD (GROUND) PRONG FROM THE POWER CORD PLUG.
ALWAYS DISCONNECT THE
ELECTRICAL PLUG FROM THE
WALL RECEPTACLE BEFORE
SERVICING THIS UNIT.
The power cord on your cooktop
is equipped with a three prong
grounding plug with polarized
parallel blades. This type of plug
is for your protection against
shock hazard. This cord must be
plugged directly into a properly
grounded 3-prong wall receptacle
that is connected to a correctly
polarized 120 volt electric power
supply. It is recommended that a
separate circuit serving each ap-
pliance be provided.
FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
MODELS:
GGS30/36/365,
GGSCV30/36/365,
SGS30, GGN30/36/365
GGNCV30/36/365 &
SGN30
Rated 120 volt, 60 Hz., 1.0 Amp.
MODELS:
SGS36G, SGSCV36G
SGN36G & SGNCV36G
Rated 120 volt, 60 Hz., 11.7 Amp
➛
Three
Prong
Plug
➛
Outlet
Cooktop
Cook'n'Vent (optional)
See Installation Instructions for electrical requirements and
grounding instructions.