Establish network communications – Tripp Lite SNMP Solo MT-SE-37/02 User Manual
Page 30

SNMP Solo
24
Final Installation
If the SNMP Solo detects three communication
failures in a row, the red LED turns on and
stays on until the SNMP Solo receives a
successful communication from the UPS.
Establish Network Communications
1. PING SNMP Solo.
Issue a PING command from the NMS. If you do not get a
response, check the SNMP Solo’s network connection and
IP address.
2. Test the adapter with an NMS.
Perform a “get” command and a “set” command. If either
command fails, check the SNMP Solo access controls. The
manager must have read permission to execute a get
command successfully and read/write permission to
execute a set command successfully.
(See the Configuring the NMS section for a detailed
discussion.)
Your SNMP Solo SNMP adapter is now
installed and completely functional.
- A012-012 (2 pages)
- N002-003-BK (3 pages)
- N490-016-LCLC (2 pages)
- N002-002-GY (3 pages)
- N002-025-YW (3 pages)
- N002-025-BL (3 pages)
- SNMPCARD (2 pages)
- N304-05M (2 pages)
- B118-302-R (12 pages)
- N002-002-BK (3 pages)
- N001-015-GY (3 pages)
- N302-08M (2 pages)
- U036-005-R (2 pages)
- N306-001 (2 pages)
- UL20276 (3 pages)
- N302-06M (2 pages)
- U256-025-R (2 pages)
- N002-025-GN (3 pages)
- N002-010-GN (3 pages)
- N201-007-BK (3 pages)
- B096-016 (4 pages)
- N002-050-GY (3 pages)
- N310-006 (3 pages)
- B132-004-RB (2 pages)
- U022-010 (2 pages)
- N201-020-BK (2 pages)
- N201-007-YW (3 pages)
- N001-050-BL (3 pages)
- N316-21M (2 pages)
- N002-025-WH (2 pages)
- N002-007-RD (3 pages)
- U007-40M (2 pages)
- N002-007-YW (3 pages)
- N304-11M (2 pages)
- N001-010-BL (3 pages)
- B112-002-R (3 pages)
- N302-18M (2 pages)
- N201-025-GN (3 pages)
- N306-05M (2 pages)
- N316-04M (2 pages)
- N201-010-GY (3 pages)
- N306-003 (2 pages)
- N310-08M (2 pages)
- 24-Port Cat5e Patch Panel N052-024 (2 pages)
- N002-003-BL (3 pages)