Teac T-R670AM - Manual (Page 24)

Setting the Clock
Sleep Timer
24
ENGLISH
1 Press the TIME SET button.
Every time the TIME SET button is pressed, the mode is
changed as follows:
ON-TIME and OFF-TIME are used when programming a built-
in timer (more on this later).
Since you are now setting up the clock, select TIME SET.
2 Press the MEMORY/SET button.
The hours start blinking.
3 Press the TIME button to set the current hour.
4 Press the MEMORY/SET button.
The minutes start blinking.
5 Press the TIME button to set the current minute.
6 Press the MEMORY/SET button.
The clock starts from 00 second.
The display is automatically switched back to show time or a
frequency number depending on whether the tuner is
currently in STANDBY mode or in its powered-up mode.
1
2
3
4
5
6
a a The power can be switched off at the desired time.
Press the SLEEP button in the on mode. Display becomes dark
and "SLEEP 90" is shown on the display. The sleep time can be
changed by 10 minutes’ step. Press the SLEEP button
repeatedly until the desired time appears.
SLEEP 90 : The power will be switched off 90 minutes later.
SLEEP 80, SLEEP 70 ...... SLEEP 10
SLEEP OFF : Sleep timer is off.
< You can check the remaining time by pressing the SLEEP
button.