Teledyne 10 - Manual (Page 16)

BioOptix™ 10
Section 1 Introduction
1-4
1.3.2 BioOptix 10 Left-side
Controls and
Connections
Figure 1-2 BioOptix 10 left-side connections
1
2
3
4
5
7
6
Table 1-3 BioOptix 10 Left-side Connections
Item Name Description
1 Buffer A Inlet Ports Ports to accept Buffer A solution for each channel.
2 Buffer B Inlet Ports Ports to accept Buffer B solution for each channel.
3 Sample In Ports Ports to accept sample for each channel.
4 Pump Purge Port When the Mode Knob is in the Purge Pump position, pumped fluids are
diverted to this port, bypassing the column, detection, and collection.
5 Waste Ports Connects to waste collection container(s). Connecting to separate contain-
ers allows isolation of waste buffers by each channel, which could be benefi-
cial should a purified sample fail to collect.
6 Internal Drain Fluid from internal leaks exit the case through this opening. Internal leaks
are the result of pump seal failures due to neglected routine maintenance.
7 Power Switch I = On
0= Off