Toshiba 32JW8UA - Manual (Page 31)

31
GETTING ST
AR
TED
USING THE TV'S
FEA
TURES
EQUIPMENT
CONNECTIONS
REFERENCE
INTRODUCTION
VIEWING
TELETEXT
Toshiba 32JW8UA (E)
REFERENCE
A Guide to Simple Problem
Solving
•
Before calling service personnel, please check the following chart for a possible cause of the
trouble you are experiencing.
Symptom
Power is not turned on.
No sound
Poor color/tint
Spots appear on the screen.
Lines appear on the screen.
Double or triple images
Snowy picture
Remote control does not
work.
Broadcast Transmission Systems in Each Country or Region
Area
Asia
M. E.
Oceania
Africa
South
America
System
Sound
B/G
D/K
I
B/G
D/K
M
B/G
I
N
M
M
Color
PAL
PAL
PAL
SECAM
SECAM
NTSC
PAL
PAL
PAL
PAL
NTSC
Country or Region
Bahrain, Kuwait, Israel, Oman, Qatar, United Arab Emirates,
Yemen, and other Middle Eastern countries.
Indonesia, Malaysia, Singapore, Thailand, and other Southeast
Asian countries.
China
China Hong Kong
Iraq, Islamic Republic of Iran, Lebanon, Saudi Arabia
Russian Federation
Myanmar
Australia, New Zealand
Republic of South Africa
Argentina, Paraguay, Uruguay
Brazil
Chile, Colombia
Notes
• PAL, SECAM and NTSC3.58 (MHz) are different color signal broadcast transmission systems applicable to different
countries. NTSC4.43 (MHz) is used in some VCRs to playback NTSC recorded video tapes through PAL television
equipment.
• Refer to the Specifications table on the next page to find the receivable television systems for your TV.
The following are not malfunctions
•
The clicking is a creaking sound produced when the cabinet expands or contracts
due to changes in the temperature. This will not affect the picture or sound.
•
If the brightness is set too high, such unevenness in color may occur depending
upon the nature of the picture. The proper color can be restored by reducing the
contrast. Consult your local dealer.
The cabinet clicks.
Unevenness in color
sometimes develops in part
of the screen.
Check these things
• Be sure the power cord is plugged in.
• The headphones may be plugged in.
• The contrast, color and tint may need to be adjusted.
•
If you change the direction of the TV while the TV is on, the picture may suffer from
color shading. If so, turn off the TV and allow about 30 minutes to cool, then turn on
the TV again. The picture should improve.
• The broadcast signal may be jammed by other electrical sources such as cars,
motorcycles, electric trains, high tension lines, neon signs, hair dryers.
•
The broadcast signal may be jammed by other TV receivers, personal computers,
and TV games, as well as interference from radio stations.
•
Interference may be due to broadcast waves reflected from mountains or buildings.
• Check if the direction of the antenna has changed due to strong wind.
• The antenna lead may be broken or disconnected.
•
Check if the direction of the antenna has changed.
•
The batteries in the remote control may be exhausted.
• The batteries may be improperly installed.
•
Check that there is no obstruction between the remote control and the remote
(infrared) sensor.
•
Check that a strong light is shining on the remote (infrared) sensor.
• Check that the main power is not turned off.
#32JW8UA_31-32.p65 04.10.25, 10:28 AM 31
Black