Toshiba kV-9168A - Manual (Page 22)

NOTICE
PREPARATION
INTRODUCTION
RECORDING OPERATION
PLAYBACK
OPERATION
SP A 2 2 H 2 H 40 M 1/60s 60.0 fields/s Possible Continuous
EP
A 6 6 H 8 H 1/60s 60.0 fields/s Possible Continuous
SP A12 14 H 18 H 40 M 0.12s 8.57 fields/s Possible Continuous
EP
A18 18 H 24 H 1/20s 20.0 fields/s Possible Continuous
(Virtual Real Time mode)
SP A24 26 H 34 H 40 M 0.22s 4.62 fields/s Possible Continuous
SP 24 24 H 32 H 0.20s 5.00 fields/s Impossible Intermittent
EP
30 (High Density mode) 30 H 40 H 0.08s 12.0 fields/s Impossible Intermittent
SP 48 48 H 64 H 0.40s 2.50 fields/s Impossible Intermittent
EP
48 (High Density mode) 48 H 64 H 0.13s 7.50 fields/s Impossible Intermittent
SP 72 72 H 96 H 0.60s 1.67 fields/s Impossible Intermittent
EP
72 (High Density mode) 72 H 96 H 0.20s 5.00 fields/s Impossible Intermittent
SP 120 120 H 160 H 1.0s 1.00 fields/s Impossible Intermittent
EP
120 (High Density mode) 120 H 160 H 0.33s 3.00 fields/s Impossible Intermittent
SP 168 168 H 224 H 1.4s 0.71 fields/s Impossible Intermittent
EP
168 (High Density mode) 168 H 224 H 0.47s 2.14 fields/s Impossible Intermittent
SP L01 3,600 H 60s 2 fields/1 min (*1) Impossible Intermittent
SP L02 7,200 H 120s 2 fields/2 min (*1) Impossible Intermittent
SP L03 10,800 H 180s 2 fields/3 min (*1) Impossible Intermittent
(*1): Without an alarm trigger input.
• The possible recording time depends on the type of video tape used.
• Audio recording is possible in the
SP A2, EP A6, SP A12, EP A18 and SP A24 modes.
• In SP L01, SP L02 or SP L03 modes, the VCR is set to recording pause mode. The alarm recording starts by an alarm trigger signal
input, and the VCR is set to recording pause mode again to wait for next alarm trigger input. When recording pause mode continues
for appointed time (
SP L01: 1 min, SP L02: 2 min, SP L03: 3 min.) without an alarm trigger input, the VCR forwards the tape 2 fields
with recording to protect the tape and the video head from damage.
i HOW TO OPERATE 24 HOUR VIRTUAL REAL TIME MODE
• In order to operate 24 hour virtual real time mode, please use T-160 VHS video tape with EP A18 record mode. EP A18 mode
means that T-120 tape will run 18 hours. However, if you use longer length of video tape which is T-160, it will record up to 24
hours with
EP A18 mode. Also, when you use EP A18 mode for recording, you will get 20 fields of video information per second,
SP A24 mode will be less than 5 fields video information per second. (Refer to the above chart for the details.)
• When using the T-160 tape, it will be necessary to replace the tape with new one and make a cleaning of the mechanical deck of
this VCR more frequently. Because, the thickness of T-160 tape is about 3/4 of T-120 tape, so durability, mechanical strength,
etc. of the tape are inferior to T-120 tape.
Record/Play Available Time Recording
interval
SETTING THE RECORDING/PLAYBACK TIME
i Before performing playback/recording, it is necessary to set the desired time mode.
21
TIMER
POWER EJECT
VIDEO MODE
TAPE REMAIN
TIME LAPSE VCR
4Head 168Hour
DISPLAY
PLAY STOP REV FWD
TIME MODE
SET
SHIFT TRACKING
LOCATION SELECT
COUNTER
ALARM RESET MEMORY
AUTO B/W COLOR
REMOTE
OFF REMOTE OPTION
BUZZER ON OFF
REC REC CHECK
+ –
PAUSE/STILL
PICTURE
SOFT SHARP
Mode display
Recording/Playback time display
SP
H
TIME MODE button: Recording/Playback time
(Using T-120) (Using T-160)
i Consult the following table to select a correct mode for your purpose.
VIRTUAL REAL TIME & TIME LAPSE VCR INFORMATION CHART
Tape running Audio record Recording field Mode display
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)