Toshiba kV-9168A - Manual (Page 13)

RECORDING OPERATION
PREPARATION
INTRODUCTION
PLAYBACK OPERATION
NOTICE
VIDEO IN VIDEO OUT
1 2 3 4 5
CAMERA
ALARM IN REMOTE
6 7 8
1 2 3 4 5 6 7 8
ALARM
OUT
MONITOR
VCR
REC VCR
PLAY
Monitor TV.
AC120V
To AC outlet
To ALARM IN
To VCR playback
Frame Sequential Switcher
To VCR REC
To ALARM
OUTPUT
To VIDEO OUT
To GND
To REC TRIGGER INPUT
To REC TRIGG. OUT
To
VIDEO IN
ALL CLEAR
REMOTE IN
MIC IN
IN
GND
RESET
OUT
GND
OUT
GND
TAPE END
ALARM
REC TRIGG.
IN OUT VIDEO
IN OUT AUDIO SEE MANUAL SEE MANUAL
IN
EXT CONT.
Typical Connection with the Sequential Switcher
When connected with a sequential switcher, set the alarm recording mode to MANUAL by menu screen.
For further details, consult the instruction manuals of the connected devices.
12
When using the VCR connected to a frame sequential switcher, pay
attention to the following matters.
i When playing back in the SP A12, EP A18 or SP A24 mode, mixing of
pictures from other channels may occur. If this occurs, play back in a
mode other than the
SP A12, EP A18 or SP A24 mode.
i If the following phenomena occur during playback in a time mode of
24 hours or longer, adjust by using the TRACKING button.
1. Mixing of signals from another channel.
Go to slow playback and press the TRACKING button to adjust
until the picture appears from the channel you want to view.
2. Picture waves up and down.
Press the TRACKING button during still picture playback and
adjust the picture until the picture stops waving up and down.