Tanita BF-562 - Manual (Page 4)

GB GB
Changing the Dry Cell Batteries
a Even if the batteries are removed, memorised personal data (birthdays, gender, heights and measurement figures)
will not be deleted.
© If the dry cell batteries are exhausted, starts to flash on the display. (You cannot operate the equipment or perform
measurement.)
Please change all four batteries immediately to ensure continued accuracy.
* While
is flashing, even if you remove the dry cell batteries, the set date and time are
maintained (for about five minutes.)
Please change the dry cell batteries as quickly as possible.
* Never use alkaline dry cell batteries together with manganese dry cell batteries, as this may cause
malfunction.
© After changing the dry cell batteries, the following displays appear. Please follow each instruction and operate the
equipment accordingly.
Lo
Lo
When you put dry cell batteries in
for the first time after purchasing
the equipment, the product will ask
you to check the calender.
a The life of the dry cell batteries is about 1 year if the
product is used once a day. The life of the batteries
included may be shorter than stated above.
a When changing dry cell batteries or operating the equipment, if the LCD behaves oddly or the switch does not work,
please remove the batteries, wait until the LCD clears (for about five minutes) and put the batteries back in again.
Display
©Press the and check the date and time in the
calendar.
•If the date or time is wrong, please correct it. (See How to change
the calendar on page 21.)
•When is displayed, please set the calendar.
(See Calendar Setting on page 10.)
Time/DOWN
ቢLocate the battery compartment behind the display box.
ባopen the battery box cover.
ቤput in the AA R6P dry
cell batteries. (Included)
Loading the batteries
U
•
When flashes for
a few seconds and then
disappears.
Lo
When nothing is displayed.
When is displayed. ©Please set the calendar. (See the Calendar Setting on page 10.)
•
•
Use
9
GB GB
2 Connect the Display Box to the Scale
Platform
Be sure to hold the plug at the end of the connection
cable and insert it into the display box. (Insert it straight
into the box so that the triangle signs on both sides
meet.)
Be sure to insert and pull out the connection cable by
holding the plug at the end of the connection cable.
Otherwise this may damage the product.
1 Installing the Scale Platform
a Use this equipment on a hard flat surface.
a If using the unit on soft carpets, attach the carpet feet.
©With the carpet feet you can
perform measurement even on
carpets up to 20 mm thick.
Caution
aDo not use carpet feet except on carpets.
This could make the product unstable.
aDo not damage the connection parts or connection
cable.
If you use force to bend, pull, twist or step on them, this may cause
failure or malfunction.
aDo not carry the equipment by holding it only by
the connection cable.
This may cause failure, breakage or malfunction, and there is a risk of
damage if you drop the equipment.
Support
(Attached)
Support
Hole Correct way
to attach foot Wrong way to
attach foot
Caution
Preparation
8
BF-562海外GB+D面付解除 ページ9