Safety – Tiger RBF-14C User Manual
Page 9
Safety Section 1-5
SAFETY
RBC - 14C 07-04
© 2004 Alamo Group Inc.
WARNING!
Avoid contact with hot surfaces of the engine or muffler. Use gloves and eye protection when
servicing hot components. Contact with a hot surface or fluid can cause serious injury from
burns or scalding.
(SG-38)
WARNING!
The rotating parts of this machine continue to rotate even after the PTO
has been turned off. The operator should remain in his seat for 60
seconds after the brake has been set, the PTO disengaged, the tractor
turned off, and all evidence of rotation has ceased.
(S3PT-10)
“Wait a minute...Save a life!”
DANGER!
Never crawl under a raised Implement supported solely by the Tractor 3-
Point hitch. Release of the control lever or mechanical failure will result
in the Implement falling and possible injury or death. Always securely
block up the Implement before crawling underneath to perform repairs and
service.
(S3PT-19)
WARNING!
The rotating parts of this machine continue to rotate even after the Tractor
has been turned off. The operator should remain in his seat for 60
seconds after the brake has been set, the PTO disengaged, the tractor
turned off, and all evidence of rotation has ceased.
(SBM-5)
“Wait a minute...Save a life!”
DANGER!
Do not put hands or feet under mower decks. Blade Contact can result
in serious injury or even death. Stay away until all motion has stopped
and the decks are securely blocked up.
(SFL-2)
WARNING!
Do not put hands or feet under mower decks. Blade Contact can result
serious injury or even death. Stay away until all motion has stopped and
the decks are securely blocked up.
(SGM-9)
WARNING!
Do not put hands or feet near the cutter bar. Blade contact can result in
serious injury. Stay away until all motion has stopped and the mower is
securely blocked up.
(SSM-1)
DANGER!
Do not operate the implement while wearing loose fitting clothing.
Entanglement of the clothing with the rotating elements can result in
serious injury or even death. Stay clear of all rotating elements at all
times.
(SSP-3)