Tiger RBF-14C - Manual (Page 77)

Operation Section 4-27
OPERATION
RBF-14C 07/04
© 2004 Alamo Group Inc.
9.4 Shutting Down the Attached Head
To shut down attached boom head, first bring the tractor
to a complete stop. Keep the engine speed at normal
operating speed of 540 RPM, and push the Motor
Switch IN to the Stop position. The mower head will
come to a complete stop with in 15 seconds.
Park the tractor on a level surface, place the transmission in park or neutral and apply the parking brake, shut down
the engine, remove the key, and wait for all motion to come to a complete stop before exiting the tractor.
10. TRACTOR, BOOM, AND ATTACHED HEAD STORAGE
Properly preparing and storing the unit at the end of the season is critical to maintaining its appearance and
to help ensure years of dependable service. The following are suggested storage procedures:
1. Thoroughly clean all debris from boom and head to
prevent damage from rotting grass and standing
water.
2. Lubricate all grease points and fill oil levels
according to the maintenance lubrication schedule.
3. Tighten all bolts to the proper torque. Ensure all
pins and other hardware are in place.
4. Check the boom arm and head for worn and
damaged parts. Perform repairs and make
replacements so that the mower will be ready for
use at the start of the next season.
5. Install leg supports to reduce tension on boom and
tank during storage.
6. Store the unit in a clean and dry location.
7. Use spray touch-up enamel where necessary on
bare metal surfaces to prevent rust and to maintain
the appearance of the mower.
DANGER! BEFORE leaving the tractor seat, always engage the brake and/or set the
tractor transmission in parking gear, disengage the PTO, stop the engine,
remove the key, and wait for all moving parts to stop. Place the tractor
shift lever into a low range or parking gear to prevent the tractor from
rolling. Never dismount a Tractor that is moving or while the engine is
running. Operate the Tractor controls from the tractor seat only.
(SG-9)
ON-OFF Switch