TC electronic SDN BHD M3000 - Manual (Page 44)

VSS™SR - SURROUND
42
Front Delay
(0 - 200ms) Changes the reverb feed delay time of the
Front/center information in the signal.
Rear Delay
Changes the reverb feed delay time of the Rear/surround
information in the signal.
Pre Delay
(0 - 100ms) A delay placed at the Input of the algorithm. This
sets how long after the dry sound the Early Reflections will
begin.
Mix
(0% - 100%) Wet/Dry mix. Can be frozen at 100% on the I/O
menu.
Out Level
(-100dB - 0dB) The overall Output level of the Reverb.
This is mostly used when the two Engines are used in serial
mode, or used in the Combined Mode.
Expert mode
Press OK to gain access to the following additional
parameters.
Note: Hi Color and Lo Color are not available in this mode.
Early Reflections
Early Type
(Several types) Pick the type that best compliments your
material or best represents the effect you are going for.
Early Size
(Small, Medium, Large) Changes the size of the Early Type
parameter.
Note: Some of the Early Types are only one size.
Early Pos
Here you can select between a Close and a Distant setting.
This enables you to change the distance between the listening
position and the source in the same Early Reflection pattern.
Note that some of the Early Types only have one position
available.
VSS™SR (Surround)
The VSS™SR (Surround) algorithm is a unique room
simulator with new facilities for surround production. The
diffused field of the simulation is turned into a Front/Rear
composition with separate Decay, Level and Predelay
parameters for front and rear.
The composite output of the simulator is compatible with
mono, stereo and surround reproduction.
When used for surround production a surround encoder is not
needed, but monitoring should be done through a Dolby SR
compatible decoding system.
Front Decay
(0.01 - 20) Changes the Decay time at the mono information
in the signal.
Rear Decay
(0.01 - 20) Changes the Decay time at the stereo information
in the signal.
Front Level
(-10dB - 0dB) Changes the level of the Front/center
information in the signal.
Rear Level
(-10dB - 0dB) Changes the level of the Rear/surround
information in the signal.
Early Lev
(-100dB - 0dB) The Output level of the Early Reflections.
When Early Lev is set all the way off, the Reverb effect will
consist entirely of Reverb tail.
Hi Color (available in easy mode only)
Adjusts the spectral balance in the high frequencies.
This is actually a simple way of adjusting a complex
selection of frequencies.
Lo Color (available in easy mode only)
Adjusting the spectral balance in the low frequencies.
A simple way of adjusting a complex selection of
frequencies.