beautypg.com

Appendix b: connections, Repair, Noise/hum – Tapco THUMP TH-15A User Manual

Page 12: Xlr connectors

background image

1

Lonely? Looking for that special someone?

Do you have a question about your TAPCO loudspeaker?

Please call our Technical Support chaps at

1-877-87-669, Monday to Friday, from 7 AM to 5 PM PST.

After hours, visit www.tapcoworld.com and look under

Talk To Us, or e-mail us at [email protected]

Noise/Hum

• Check the signal cable between the

mixer and the loudspeaker. Make sure all

connections are secure. These problems

usually produce crackling noises or hum.

• If you are using two or more TH-15A

active loudspeakers, try plugging them all

into the same AC outlet panel or outlet

strip. The purpose for this is to connect

them all to the same earth ground point

and reduce the possibility of creating a

ground loop.

• If connecting an unbalanced output

to the TH-15A balanced input, make

sure the shield is connected to the

unbalanced ground and to pin 1 of the

XLR.

Repair

For warranty repair or replacement, refer

to the warranty information on page 15.

Non-warranty repair for TAPCO products

is available at a factory-authorized service

center. To locate your nearest service

center, call our Tech Support department at

1-877-827-2669, Monday-Friday,

7 am to 5 pm Pacific Time, to explain the

problem. Tech Support will tell you where

the nearest factory-authorized service

center is located in your area.

Appendix B:

Connections

XLR Connectors

XLR connectors are used to make

balanced input and through connections

to the TH-15A. They are wired as follows,

according to standards specified by the AES

(Audio Engineering Society).

XLR Balanced Wiring
Pin 1 = Shield
Pin 2 = Hot (+)
Pin 3 = Cold (–)

2

2

3

1

1

SHIELD

COLD

HOT

SHIELD

COLD

HOT

3

SHIELD

COLD

HOT

3

2

1