Transcend Information TS128M~8GJF2A - Manual (Page 14)

Create Two Partitions
Slide the Disk-Volume bar to adjust the size of Disk1 to fit your needs. The size of Disk2
will be changed automatically according to the size of Disk1, as adjusted by the user.
JetFlash can be setup to a USB-ZIP or USB-HDD boot-up mode as indicated below.
Option
Disk 1
Size
Disk 1
Configuration
Disk 2
Configuration
BIOS
1 >2 MB
Make USB-ZIP
startup disk
Blank USB-ZIP
2 >2 MB
Make USB-HDD
startup disk
Blank USB-HDD
Windows 2000 cannot recognize the second partition. Please download the Windows
2000 Service Pack 3 or later version from the Microsoft website and install it. Windows
2000 will then be able to recognize the second partition.
For Mac computers, only Mac OS 10.1.5 or later can recognize the partitions.
Even if two partitions are created, only Disk1 can be recognized under the MS-DOS
prompt after booting up from JetFlash.
When Enable password protection option is selected, Disk1 will be a public disk and
Disk2 will be a password-protected disk after format.
Option 1: Make an USB-ZIP startup disk
a. Select Type of format (Quick, Full or Configure device only) and slide the
Disk-Volume bar to set the size of Disk1 to fit your needs and Disk2 will be
changed automatically according to the size of Disk1. Select Make USB-ZIP
startup disk on Disk 1. Click Start to continue.
12