Format introduction – Transcend Information TS128M~8GJF2A User Manual

Page 10

Format Introduction

JetFlash Product Number,
Drive Letter and Capacity

Information of Partitioned Disk 1

Disk-Volume bar. Use it to make
two partitions and adjust the
capacity sizes. The minimum
size is 2MB.

Information of Partitioned Disk 2

Progress bar

Type of Format

Quick: Erase and check blocks at the same time. If there are any bad blocks, mark

them as Bad and perform a DOS format.

Full:

Do a Surface Scan for a Read/Write Check. A Read/Write Check can find if

there is any bad block which will be marked as Bad and perform a DOS format.

Configure device only:

Partition JetFlash, and set up password protection and

boot-up information.

Configure device only cannot be setup under password protection.

WARNING: All data on JetFlash will be lost during execution of this procedure!