TP-Link TL-R402M - Manual (Page 28)

TL-R402M Cable/DSL Router User Guide
21
Figure 4-11 DHCP Settings
¾ DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network or else you must manually configure the
computer
¾
Start IP Address - This field specifies the first of the addresses in the IP address pool.
192.168.1.100 is the default start address
¾
End IP Address - This field specifies the last of the addresses in the IP address pool.
192.168.1.199 is the default end address
¾
Address Lease Time - The Address Lease Time is the amount of time a network user will
be allowed connection to the router with their current dynamic IP address. Enter the amount
of time, in minutes, which the user will be "leased" this dynamic IP address. The range of the
time is 1 ~ 2880 minutes. The default value is 120 minutes
¾ Default Gateway - (Optional.) Suggest to input the IP address of the LAN port of the router,
default value is 192.168.1.1
¾
Default Domain - (Optional.) Input the domain name of your network
¾
Primary DNS - (Optional.) Input the DNS IP address provided by your ISP. Or consult your
ISP
¾
Secondary DNS - (Optional.) Input the IP address of another DNS server if your ISP
provides two DNS servers
)
Note:
To use the DHCP server function of the router, you must configure all computers on the LAN as
"Obtain an IP Address automatically" mode. This function will take effect until the router reboots.
4.5.2 DHCP Clients List
This page shows Client Name, MAC Address, Assigned IP and Lease Time for each DHCP