Auto ribbon saving mode, 5 auto ribbon saving mode - 5, 5 auto ribbon saving mode – Toshiba B-470-QQ Series User Manual
Page 26
10-5
Auto ribbon saving function is activated when it is selected by DIP switch (Refer to page 4-1) and no
print area extends more than 20 mm.
NOTE: According to the relation between the outer diameter of rewound ribbon and print speed,
ribbon loss per saving varies as follows:
Print speed
3"/sec.
6"/sec.
10"/sec.
Ribbon loss
Approx. 6 mm
Approx. 10 mm
Approx. 20 mm
Threshold setting procedure (For firmware version 2.5 or earlier)
1
Turn the power on.
2
Load the pre-printed label. (Any position)
3
Press the [PAUSE] key once.
4
Hold down the [PAUSE] key for more than 3 seconds and it will begin to feed. After it has fed the 2 label,
release the [PAUSE] key.
5
Press the [RESTART] key for ON LINE mode.
6
Threshold setting is now completed.
NOTES: 1. If the [PAUSE] key is not held down for more than 3 seconds in PAUSE mode the threshold
will not be set.
2. If the [PAUSE] key is released before 2 labels have been issued the setting may not be correct
and will have to be re-set.
10. GENERAL MAINTENANCE
EM1-33033
10.4 Threshold Setting