Model identification and differences – Texas Instruments 8200IC User Manual
Page 10
Model Identification and Differences
Identify Model
The nameplate, located behind the storage door, identifies the 3M Digital WallDisplay (DWD). Push the storage
door to open it. The figure below shows the nameplate, and the table shows the model numbers and correspon-
ding model names.
Model Number
Model Name
8000DP
3M Digital WallDisplay 8000DP for Projection Display
8000VC
3M Digital WallDisplay 8000VC for Video Teleconferencing
8100CB
3M Digital WallDisplay 8100CB with Copyboard Display
8200IC
3M Digital WallDisplay 8200IC with Interactive Collaboration
8200IW
3M Digital WallDisplay 8200IW with Interactive Whiteboard
Model Differences
Below is a table that identifies the differences between the 3M Digital WallDisplay models.
Model Number
Projection Screen
Copyboard*
Interactive Whiteboard**
8000DP
Easy Dry-Erase and
NO
NO
Projection
8000VC
3M Vikuiti High Brightness
NO
NO
for projection only
8100CB
Easy Dry-Erase and
YES
NO
Projection
8200IW Easy Dry-Erase and
NO YES
Projection
8200IC
Standard Projection
YES
YES
and Dry-Erase
*The Copyboard feature allows you to print notes written on the 3M Digital WallDisplay to an attached
printer. (PCL3 compatible printer required. See list in Appendix.)
** The Digital Whiteboard feature allows you to capture notes written on the 3M Digital WallDisplay with
an attached computer or use the 3M Digital WallDisplay as an interactive display for a computer.
10
Introduction
3M™ Digital WallDisplay
© 3M 2003. All Rights Reserved.
CAUTION
Do not use markers, dry-erase or otherwise, on the 3M Digital WallDisplay
for Video Teleconferencing screen. Marks cannot be removed from the
3M Vikuiti High Brightness projection screen.
Model Number