Texas Instruments ADS8402 - Manual (Page 13)

Reference
2-3 Analog Interface
Figure 2 - 1. Input Buffer Circuit
1 k Ω
1 k Ω
+V
CC
V
I
0.1 µ F
1 µ F
25 Ω
(+) IN
( - ) IN
6800 pF
1 µ F
0.1 µ F
1 k Ω
- V
CC
-
+
60 pF
1 k Ω
60 pF
V
OCM 25 Ω
-
+
THS4503
+2.048 V
2.2 Reference
The EVM allows users to select from three reference sources. The
ADS8402/ADS8412EVM provides an onboard 4.096-V reference, U3. The
EVM also has the provision for users to supply a reference voltage via
connecter P1 pin 20. The user reference voltage and onboard reference
voltages can be filtered by installing amplifier U1. Both the ADS8402 and
ADS8412 analog-to-digital converters have integrated onboard reference
buffers; therefore, it is not necessary to buffer the voltage externally. The
reference buffer circuit on the EVM is not populated with an amplifier. The EVM
comes installed with an on-chip internal reference tied directly to the reference
pin of the converter. See Chapter 6 for the schematic.
Table 2 - 2. Solder Short Jumper Setting
Reference
Description
Jumper Setting
Reference
Designator
Description
1 - 2 2 - 3
SJP1 Not used on the EVM
SJP2 On-chip internal reference applied to reference pin Installed †
SJP3 Apply reference voltage from external source Not Installed Installed
Apply voltage to amplifier, U2, common-mode voltage pin Installed † N/A
SJP4 Buffer onboard reference, REF3040 Installed Not installed
Buffer user reference voltage applied at P1 pin 20. Not Installed Installed
SJP5 Select REF3040 for reference voltage Installed Not installed
Select buffered reference voltage Not Installed Installed
† Factory set condition