Toshiba Strata DKT2404-DECT - Manual (Page 22)

Installation
Step 2: Select Location
12
Strata CIX DKT2404-DECT User Guide 04/09
Step 2: Select Location
1. Select a location that is not subject to excessive heat or humidity. Keep the base
unit and handset away from sources of electrical noise, such as motors and
fluorescent lighting.
2. Determine if the base unit will sit on your desk or be wall mounted. If wall mounted,
go to Step 6: “Wall Installation (Optional)” .
3. Place the base unit on a desk or tabletop near a standard 120VAC outlet and
within reach of the Strata CIX digital line connection.
Important! Place the base unit to the right of the DKT. If placed on the left, the cord-
less antenna picks up a tone due to its close proximity to the DKT
speaker and electronic parts.
Step 3: Place DP/DKT-series Telephones
into 2000-Mode
You must place your DP/DKT-series telephone into 2000-mode before connecting the
cordless telephone; otherwise, the telephone will not work.
In 2000-mode, the DKT3000 telephone operation changes are:
• Only 16 characters by two lines display on the LCD.
• LCD Feature button does not work
• Spdial button does not work
ä
To change DKT3000-series telephones into 2000-mode
1. On the DKT3000 telephone, press 3+6+9+Hold (simultaneously).
2. Press #.
3. Press FB7 (or FB10 on the DKT3014). LED On = 2000 mode. LED Off = 3000
mode.
Note Flexible Buttons (FB) are numbered from the bottom up and left to right.
FB7 for example would be the seventh button up on the left.
4. Press Hold.
5. Lift the handset to exit programming mode. Wait a few seconds for the telephone
to reset itself.