Perreaux E160 - Manual (Page 8)

7
1 1 1 1
Unpacking and Placement
The E160 is packaged for maximum protection. Please carefully read the
instructions below before proceeding to unpack the unit. Be extremely careful.
Unpacking
Procedure
àInspect both ends of the cardboard box and open at the end without the
central staple by slitting the reinforced tape at either side.
àFold back the flaps and tip the package on end and the inner box will
slide out.
àLay the inner box down flat and upright, open it conventionally by
separating the top tray from the bottom.
àThe product can now be removed from the bottom packaging. This will
be easier if you have someone to help you by holding the base of the
box.
àAlternately, the bottom tray and amplifier could be tipped upside down
and the bottom packaging removed. If opened in this manner, please
ensure that you turn the contents over again.
Note: Be very careful to secure the unit if you are planning to flip the package
upside down.
àRemove the two white polystyrene protectors off either side of the
amplifier, leaving the black material covering.
àPull back the material and remove the protective black tissue from the
front panel.
The amplifier is now unpacked and ready for further installation.
Note: Please retain all packaging material for future transport.
Box
Contents
1 x E160 Power amplifier
1 x E160 Product manual
1 x Detachable AC power cord
Placing
Your E160
The E160 should generally be placed close to your source component, keeping
the interconnect cabling short.
We strongly recommend keeping the E160 on it’s own separate shelf to allow
for proper ventilation.