Perreaux E160 User Manual
Page 14
13
AC Mains Input and Fuse
AC Mains Input
An IEC-standard mains input is provided at the rear of the unit. The AC cord set
is removable, allowing you to upgrade to a cord set of your preference.
Caution! Prior to connection to the AC mains, please check the voltage label on
the rear panel to ensure that your unit conforms to the power supply in
your area. Never attempt to connect the unit to the incorrect voltage.
Severe damage can result from applying incorrect voltage to the unit.
Mains Fuse
The E160 is equipped with a user serviceable AC mains fuse. In the event of
fuse failure, always replace with the same type and value fuse. Remember, fuses
do not usually blow without a reason. Any doubts about fuse failure should be
conveyed directly to your Perreaux dealer.
For more information on fuse ratings, please refer to Chapter 13
“Specifications”.
Caution! This is the ONLY user accessible fuse.
Never replace the fuses with any other ratings other than the one
specified on the rear panel.
Always ensure your E160 is disconnected from the mains supply before
attempting to change the mains fuse.
Input Voltage and Fuse Rating
Input Voltage
It is important that the E160 be operated from the correct AC mains voltage.
This unit is factory set for the voltage applicable to the original country of
destination.
The E160 will operate satisfactorily within a voltage variation of up to ±5% of
that voltage at which the unit has been set.
If you require the voltage setting to be altered, e.g. relocation to another area,
city or country, or extraordinarily high or low voltages, please contact your
Perreaux dealer. Qualified service personnel can only perform this modification.
Caution! Never attempt to connect the unit to the incorrect voltage. Severe
damage can result from applying incorrect voltage to the unit.
Fuse Rating
The fuse rating displayed here, refers to the rating of the mains inlet fuse.
For more information on fuse ratings, please refer to Chapter 13
“Specifications”.
Caution! Never replace the fuses with any other ratings other than the one
specified.