T+A Elektroakustik K 6 - Manual (Page 57)

57 Appendix
Problem: The picture is too small, or not
shown completely (cut off).
Cause 1: The DVD in the drawer is not set to the
video format (4:3 or 16:9) of the con-
nected TV set.
Remedy: Set the correct video format in the
'Player Setup Menu'.
Cause 2: Many DVDs contain film versions in
different video formats on the front and
back faces.
Remedy: Turn the DVD over, or set the correct
video format in the 'Player Setup
Menu'.
Cause 3: TV is set to the wrong picture format.
Remedy: Set TV to correct video format, i.e. the
format matching the DVD.
Problem: Some functions are not carried out
by the K6.
Cause 1: Function not available for this DVD.
Cause 2: Function (e.g. camera angle, sub-titles
etc.) not present on this DVD.
Remedy: No remedy.
Problem: After inserting a DVD a note on in-
correct regional code appears.
Cause: The DVD is not approved for use in
Europe.
Remedy: Return disc to your DVD dealer and
exchange it for a European version.
Problem: In rare cases the disc menu function
of the DVD cannot be operated if the
video format is set to 'Pan Scan'.
Remedy: Change picture format to 'Letterbox';
then call up the disc menu function
again.
Problems in Tuner mode:
Problem: Very few stations, or even none at
all, can be received.
Cause: The aerial system or aerial cable is
defective.
Remedy: Check the aerial cable for good contact in
the aerial socket and on the K6 itself.
There must be no damage, and no kinks
in the cable. If necessary fit a new aerial
cable.
Problem: After a house move the integral
screen still displays the old program
names - but the stations can no
longer be picked up.
Cause: Programs with station names and re-
ception frequencies are still stored in
the K6, but they can no longer be re-
ceived in the new locality.
Remedy 1: Clear the programs which cannot be
received individually (see 'Clearing
Programs').
Remedy 2:
Clear all stored programs:
Switch the K6 off, then on again. After
switching on press the Select button
below the unit's front panel until a run-
ning script appears on the screen.
  
Select Change
Button buttons
Now hold the left change button
pressed in until the integral screen
displays the message:
' P R E S - C L E A R ' ' P R E S - C L E A R ' ' P R E S - C L E A R ' ' P R E S - C L E A R '
Finally press the     button on the
remote control handset for about three
seconds, until the screen reverts to the
normal display. All the stored programs
have now been cleared.
Problem: The RDS station name does not ap-
pear on the integral screen.
Cause 1: The station does not broadcast RDS
information, or the station is not cor-
rectly tuned.
Remedy: Tune in the station so that the tuning
indicator is central.
Cause 2: The station is received with interfer-
ence, or the field strength is too low.
Remedy: Select stations which can be picked up
without background hiss and interference.
Problem: When you switch programs, the RDS
station name is not displayed cor-
rectly.
Cause: The transmitter is broadcasting the
RDS station name as a running script,
which is contrary to the norm.
Remedy: Rename program (see 'Renaming a
program').