T+A Elektroakustik K 6 - Manual (Page 34)

Basic settings 34
Configuration Menu
OK
OK
OK
OK STOP / / / / / OK
Select
menu point
Change
value
on
off
english
start
menu
linked
menu
menu
on
on
off
off
Configuration
english deutsch other
languages
linked split
Switch TV output for On-Screen main menu on / off:
If you just wish to adjust the balance or tone controls
temporarily, it is not essential to access the main menu
(see 'Main Menu' menu control system) on the TV
screen, as this would superimpose it on the film you are
watching. In most cases displaying the menu on the
integral screen is perfectly adequate. This menu point
enables you to switch the TV screen display of the Main
Menu on and off.
Switch on-screen menu for VCR/TV B on / off:
A video recorder (VCR) or a TV set (e.g. in an adjacent
room – room B) can be connected to the VCR / TV B
SCART output. If you use this output for a VCR, any
superimposed menus would be recorded along with the
programme material, so as standard the on-screen
menus are switched off for this output. However, if you
connect a TV set to this output you will want to see the
on-screen menus, and this menu point enables you to
switch them on.
On-Screen Language:
The on-screen menus can be displayed on the screen in
various languages. In this menu point you select the
language you wish to see.
Setup assistant:
The 'Setup assistant' menu point represents an alterna-
tive to the manual 'Loudspeaker Menu' (see below).
Calling up the Assistant invokes an automated routine for
correctly setting up the individual loudspeaker channels
of your surround system.
Loudspeaker:
The purpose of the 'Loudspeaker Menu' is to control the
distribution of the output signals to the loudspeaker sys-
tem in your room. This menu is also used to adjust the
loudspeakers to suit the spatial and acoustic character-
istics of your listening room.
Volume A/B:
This menu point allows you to decide whether the vol-
ume controls for
    A and     B are to work separately or
linked together ( see 'Adjacent Room Operation' ).
Select one of the following settings:
split if you wish to have independent control
of the volume of     A and     B (A/B).
linked if you prefer to control the volume of     A
and     B (A+B) together.
Video norm:
The 'Video Norm Menu' enables you to set all the video
inputs and outputs of the K6 to the appropriate video
norm to suit the picture sources connected to it.
The 'Video Norm Menu' also allows you to adjust the K6
to suit the characteristics of your TV set.
Inputs:
Some AV source devices supply a digital output signal.
Alternative input sockets on the K6 can be assigned to
these source devices; these inputs are designed specifi-
cally for digital signals (coaxial or optical).
If you do this, the assigned digital signal is accepted and
processed by the decoder instead of the analogue stereo
input signal.
The alternative inputs are assigned in the 'Inputs Menu'.