Toshiba WL68 - Manual (Page 22)

1/2 SET UP
Language English
Country UK
Auto tuning OK
Manual tuning OK
AV connection OK
Picture position OK
MENU Back EXIT Watch TV
Input selection and
AV connections
22
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
B until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g. B 2S (EXT 2S), indicates the
input is set for an S-Video signal.
Use the Input Selection if the television does not switch
over automatically.
Input selection
1
2
Press B to select B 1 , B 2 , B 3C (EXT1-3),
HDMI1 , HDMI2, HDMI3 or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press B again or
one of the numbered buttons.
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press down until
AV connection
is highlighted, then press OK.
With left or right select either AV or S-VIDEO as
the required input for EXT2.
If the colour is missing try the alternative setting.
INPUT signal selection
1
2
AV connection
PC/HDMI1 audio PC
HDMI1 audio Digital
EXT2 input AV
Woofer Internal
MENU Back EXIT Watch TV
g p g