Thermador DWHD64CS - Manual (Page 15)

13
Figure 24
Cancel Drain
Canceling or Changing a Cycle
To cancel or change a cycle, open the
dishwasher door far enough to expose the control
buttons then press and hold for three seconds the
two buttons labeled “Cancel Drain” as shown in
Figure 24.
Operating the Dishwasher
(continued)
Wait approximately one minute, then press the
On/Off button
You may now begin a new cycle.
Dishware Drying
At the end of the cycle the dishwasher will stop
and a period of condensation drying will follow.
After 12 - 15 minutes of drying:
• the cycle countdown display will read “0”.
• the “Sanitized” light may appear. See section
on Sanitization for more information.
NOTE: If your household water supply is too hot,
your dishwasher’s heating time may be reduced
and the “Sanitized” light may not illuminate. Your
Dishwasher Installation Manual has information
on the recommended temperature for your
household hot water supply.
NOTE: To accelerate and enhance drying, open
the dishwasher door, pull the top rack a few
inches out of the dishwasher, and prop the
dishwasher door against the top rack.
Hygiene Dry
This feature senses when the unit is low on rinse
agent and automatically increases the drying
time.
Additional Drying Heat
With this option you can raise the temperature of
the rinse water and increase the drying time,
which will result in improved drying.
Press and hold the left “Cancel Drain” button,
then press and hold the On/Off button.
When the LED display shows a “0” or a “1”,
release both buttons.
To enable the Additional Drying Heat, press the
left “Cancel Drain” button until the LED display
shows a “1”.
To disable the Additional Drying Heat, press the
left “Cancel Drain” button until the LED display
shows a “0”.
Press the On/Off button to save the setting.
The Cycle Completion Signal
This Cycle Completion Signal is a tone that
sounds when your dishwasher finishes washing
and drying your dishes. You can either disable the
tone, or you can set it at one of two volumes (your
dishwasher leaves our factory with the tone set
on the lower volume).
To change the Cycle Completion Signal Volume:
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press and hold the right “Cancel Drain” as
shown in Figure 25, then press and hold the
On/Off button.
Power
Scrub
Plus
Regular
Wash
Cancel Drain
Delicate
/Econo
Figure 25
3. When the light on the “Cancel Drain” button
you are pressing illuminates and the tone
begins to sound, release both buttons.
4. Press the right-most “Cancel Drain” button
until the tone is either at the desired volume
or is silent.
5. Press the On/Off Button.
6. Shut the dishwasher door. The Cycle
Completion Signal is now set, and you may
wash your dishes as usual.