Toshiba MW24F11 - Manual (Page 42)

42
Other functions (VCR)
LINE 1 IN
VIDEO
AUDIO L(MONO)
R
VIDEO
AUDIO L
R
OUT PUT
DIGITAL AUDIO
VHF/UHF
COAXIAL
To AUDIO (R) IN
To AUDIO (L) OUT Audio/Video cable (not supplied)
Playback VCR
To VIDEO OUT To AUDIO (R) OUT
Recording VCR
Duplicating a video tape
If you connect the unit to another VCR or Camcorder, you can
duplicate a previously recorded tape. Make all connections before
turning on the power.
Duplicating a video tape
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s
instructions. A typical camcorder dubbing hookup is
shown above.
Audio/Video cable (not supplied)
To AUDIO (R) IN
To AUDIO (L) IN
To VIDEO IN
Recording VCR
To AV Jack
Playback Camcorder
Connection with Camcorder
• Select “LINE2” on step 2.
Press SPEED to select the desired tape speed
SP or SLP.
It is recommended that you set the
Speed to the SP mode on the
recording VCR for best results.
1
Press INPUT once or twice to select AUDIO/
VIDEO input position.
“LINE1” or “LINE2” will appear on the
screen.
2
Press PLAY on the playback VCR or camcorder.
3 Press REC.
4
Press STOP after duplicating a video tape. 5
LINE1: on the rear panel
LINE2: on the front panel
Preparation:
• Press TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
LINE1
To VIDEO IN
To AUDIO (L) IN
Note:
Unauthorized recording of copyrighted television programs, films,
video cassettes and other materials may infringe the rights of
copyright owners and be contrary to copyright laws.
Connection with second video recorder
• Select “LINE1” on step 2.
Illustration of MW20F11
TV/VCR
INPUT
STOP
REC
SPEED
5T40301A [E]p42-43 3/1/05, 10:18 42