Thermador CGX365 - Manual (Page 26)

4A. CONNECT ELECTRICAL SUPPLY –
CGX MODELS
Before connecting the 5-foot supply cord to wall
receptacle make certain that gas shut-off valve is
in the “OFF” position.
WARNING: Before turning on the power, be
sure that all controls on the cooktop are turned
"OFF"
4B. CONNECT ELECTRICAL SUPPLY –
CD MODELS
1. Attach flexible conduit to the junction box.
2. Connect the cooktop lead wires to the junction
box supply wires in proper phase: connect black
(L1) to black, white (neutral) to white, red
(L2) to red and bare wire to ground.
NOTE: If the cooktop is installed and connected
as specified above, it will be completely grounded
in compliance with the National Electrical Code.
ELECTRICAL CONNECTION / FINAL CHECK / BEFORE FIRST USE
Page 24
5. FINAL CHECK
After electrical connection is complete, place
each burner cap in correct notched position and
check operation of electric igniters. See Page 16.
Check flame characteristics. Flame should be blue
with no yellow tip.
6. BEFORE FIRST USE
Remove everything from the cooktop surface and
apply Cooktop Cleaning Creme (packaged with
cooktop), as directed in Care section of the
manual, Page 8.
CAUTION: Your cooktop surface needs to be
cleaned daily. Refer to the Care and Use section
before using it for the first time.
▲
!
▲
!
CONNECT GAS SUPPLY, Continued
For Massachusetts Installations:
1. Shut-off valve must be a “T” handle gas cock.
2. Flexible gas connector must not be longer than 36 inches.
3. Not approved for installation in a bedroom or a bathroom unless unit is direct vent.