Switch – D-Link DMC-810SC User Manual

Page 9

Link Status

Disconnect

Link 1

Link 2

Link 3

Link 4

Cable 1

Off

Cable 2

Off

Cable 3

Off

Cable 4

Off

NOTE: If connecting two converters with LLR function in both end, it is recommended that the monitor
end converter had to turn off the LLR function, and turn on the LLR function of the remote end

converter.

1 2

Switch 1 : On -> Forced Mode

Off -> Auto Negotiation mode

Switch 2 : On -> LLR enable

Off -> LLR disable

Switch

There is a two pin DIP switch on the module which define as
switch 1 and switch 2:
Switch 1: Fiber mode switch

When the switch was turned to “On”, it means that the

fiber was turned to forced mode, and “Off” for
auto-negotiation mode.

Note: Be sure the opposite end is using the same setting (forced or Auto-negotiation).
And when using two converters at the same time, the two converters MUST set to
forced mode.

Switch 2: LLR
When the switch was turned to “On”, it means that the
LLR was enabled and “Off” for disabled.

Note: When using two converters, don’t enable the both device’s LLR function at the