Toshiba 32HL85 - Manual (Page 24)

24
(E)32HL85
Setting up
y
our T
V
1 2 3
4 5 6
7 8 9
ENTT 100 1 0 0
POWER RECALL
CHRTN
FAV
FAV V
TV / VIDEO
+10
INFO
VOL CH
DVDMENU
U
R
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
Adding channels to the TV’s memory
When you press Channel y or z, your TV will stop only on the
channels you programmed into the TV’s channel memory.
Follow the steps below and on the next page to program channels
into the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in the channel memory. After the channels are
programmed automatically, you can manually add or erase individual
channels (see page 25).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z to highlight TV/CABLE.
3. Press x or • to select either TV (if you use an antenna) or
CABLE (if you use cable channels).
CH LABELING
ADD/ERASE
CH PROGRAM
TV/CABLE
LANGUAGE
SET UP
MENU BACK WATCH TV EXIT
ENGLISH
CABLE
ADD
VIDEO LABEL
ENTER
ENTER
1/2
4. Press z to select CH PROGRAM.
CH LABELING
ADD/ERASE
CH PROGRAM
TV/CABLE
LANGUAGE
SET UP
MENU BACK WATCH TV EXIT
ENGLISH
CABLE
ADD
VIDEO LABEL
ENTER
ENTER
1/2
5. Press ENTER to start channel programming. The TV will
automatically cycle through every channel (TV or Cable,
depending on which you selected in step 3), and store all active
channels in the channel memory.
While the TV is cycling through the channels, the message
“Programming Now—Please Wait” appears.
6. When channel programming is complete, the message
“Completed” appears.
7. Press Channel y or z to view the programmed channels.
MENU
yzx •
Channel yz
ENTER
Channel
Numbers
#01E22-25_32HL85 05.5.11, 5:44 PM 24
Black