Toshiba W-609 - Manual (Page 16)

16
Incoming Antenna/Cable(CATV) Signals
The VCR scans through all receivable TV and CATV channels and stores only the active
ones in your area into the memory. Once the storing is finished, you can select a desired
channel using CH/TRK.
Preparation
• Turn on the TV, and select the video channel (3 or 4), or the video input mode if you made the Audio/Video
connection (page 11).
• Press I.SELECT so that the channel number will appear if “L1” or “L2” is displayed in the VCR display.
Incoming Antenna/Cable(CATV) Signals
1 Press PROG. to display the MENU screen.
2 Select “PRESET” using FF or REW,
and press ENTER.
3 Select “CH MEMORY” using PLAY
or STOP, and press ENTER.
4 Set “TV/CATV“ to “TV” or “CATV” using FF or REW.
TV: To store channels received via the antenna.
CATV: To store channels received via the incoming cable.
5 Select “AUTO SCAN” using PLAY or
STOP, and press FF to set to “ON”.
The VCR starts scanning and the
channels are stored in the VCR in
ascending order. When the scanning is
finished, the screen automatically
returns.
6 Press PROG. three times to exit.
PREPARATION
Number
buttons
Storing Channels on the VCR
This section is required if you receive only normal TV or unscrambled cable channels, or use a cable box
between your TV and the VCR.
E n D : PROG
SET UP PRESET PROGRAM
TV/CATV TV CATV
AUTO SCA n OFF O n
ADD CH - - CH
ERASE CH - - CH
E n D : PROG
SET UP PRESET PROGRAM
AUTO SCA n 2 CH on
1, 6
7 8
0 100
9
6 5
2 3
4
1
STOP
PLAY
FF REW
100
FF
PLAY, STOP
ENTER
REW
I.SELECT
E n D : PROG
SET UP PRESET PROGRAM
ENTER
CLOCK SET
CH MEMORY
CABLE BOX / DSS
GUIDE CH
W-609/TSB DRAFT(10-18)01 26/11/99, 8:18 PM 16