Texas Instruments MC-780PIx - Manual (Page 14)

Mounting System
2-2 Nomenclature and Use of Each Component
2.1 Mounting System
The following paragraphs describe the mounting system for the camera
modules.
2.1.1 Focus Ring
C-Mount type lens and optical equipment are installed. If there is difficulty fo-
cusing with the lens, fine adjustments can be made by loosening the two
screws located on the ring. The lens can also be brought back closer to the
CCD by removing the focus ring.
2.1.2 Mounting Holes A
There are four screw holes on the top and bottom for mounting the camera
module. The gauge is M2.6 and the depth is 4.5 mm.
2.1.3 Mounting Hole B
There is a screw hole on the bottom for mounting the camera module. The
gauge is M4 and the depth is 6 mm.
2.1.4 Mounting Holes C
There are screw holes on the bottom for mounting the camera module to a
tripod. The gauge is 1/4UNC and the depth is 6 mm.