Trek Incite 6i - Manual (Page 6)

5
To set Clock
1. Cycle Mode to CLK.
2. Hold Mode.
3. Cycle Set to 12 or 24 hour clock.
4. Push Mode to select clock.
5. Cycle Set to the hour.
6. Push Mode to select.
7. Cycle Set to the minute.
8. Push Mode to select.
The computer returns to current speed.
To Restart the trip modes
The trip modes include TRP, AVG, TME, and MAX. This operation sets all four values to zero, allowing
the computer to display information for a single ride.
1. Cycle
Mode to MAX.
2. Hold Set, and do not let up until after completing step 3.
3. Hold Mode.
The Max setting restarts at ʻ0ʼ.
Second wheel size (Wheel 2)
The following features are only on the Incite 8i. The second wheel size allows the computer to
calculate using the wheel size of a second bike. For example, you can use the computer on your road
bike with 700c racing wheels, then move it to your mountain bike with 26” wheels. In both cases, the
trip distance and speed will be accurate. The computer adds the data for the two wheel sizes resulting
in the total distance (ODO).
Step 8 in these instructions assumes you want to leave the odometer at its existing setting. If you
want to change the odometer, refer to the steps in To set the odometer and wheel size.
To set second wheel size
1. Cycle Mode to ODO.
2. Hold Mode.
The mileage conversion (MH or KMH) will flash.
3. Cycle Set to your preferred conversion.
4. Press Mode to select .
The wheel size for Wheel 1 appears.
5. Hold both Mode and Set at the same time.
The wheel select icon appears in the upper left corner.
6. Cycle Set to your second wheel size.
7. Push Mode to select.
8. Push Mode to select each digit of the odometer.
The computer returns to current speed.
To select Wheel 2
1. Cycle Mode to TRP.
2. Hold Mode to select other wheel size.
Setting the computer