Trek Incite 6i - Manual (Page 5)

4
SETTING THE COMPUTER
The computer must be set, or “programmed,” so that it gives its readout in the units preferred by the
user, and so that it calculates with the correct wheel size. There are three ways to use the buttons:
• Push- touch once
• Cycle- push repeatedly as needed
• Hold- push and hold in for two or three seconds
The method used to set the computer varies according to the computer model. Follow the instruc-
tions covering your computer model, grouped as follows:
• Incite 6i and 8i (pages 7-9)
• Incite 9i and 11i (pages 10-12)
INCITE 6I AND 8I
Setting the 6i and 8i is done by pushing the two buttons in a specific sequence. The button on the
side of the computer is the Set button. The large button on the bottom, which may look like two
buttons, is the Mode button.
To set Odometer and Wheel size
By default, the odometer always starts at ‘0’. If desired, the odometer can be manually set at another
value.
1. Cycle
Mode to ODO.
2. Hold Mode until MH flashes.
3. Cycle Set between MH and KMH.
4. Push Mode to select measurement conversion.
5. Cycle Set to the preferred wheel size.
For a custom wheel size, see To set a custom wheel size
6. Push Mode to select wheel size.
7. Cycle Set for the first digit of Odometer.
8. Push Mode to select the digit.
9. Repeat steps 7 and 8 to select the other digits of Odometer.
The computer returns to current speed.
To set Custom wheel size
1. Cycle Mode to ODO.
2. Hold Mode until MH flashes.
3. Cycle Set between MH and KMH.
4. Push Mode to select measurement conversion.
5. Cycle Set to the four-digit number (see Table 2).
Table 2- Wheel size and corresponding settings in millimeters
700 x 20 2086 26 x 1.5 2010
700 x 23 2096 26 x 1.90 2045
700 x 25 2105 26 x 1.95 2050
700 x 28 2136 26 x 2.0 2055
700 x 32 2155 26 x 2.1 2068
700 x 35 2168 26 x 2.2 2075
700 x 38 2180 Custom 0000 - 2999
6. Hold Set until the last digit flashes.
7. Cycle Set to your preferred value for the digit.
8. Push Mode to select.
9. Repeat steps 7 and 8 to select the other three digits.
10. Push
Mode.
10. Cycle Set for the first digit of Odometer.
11. Push Mode to select the digit.
12. Repeat steps 10 and 11 to select the other digits of Odometer.
The computer returns to current speed display.
Setting the computer