Technicolor - Thomson CP-2016-007 - Manual (Page 14)

9
Setup
2. Confirm the Aura SoHo™ Conference Phone is connected
properly by pressing the Power button �. The keypad back light
will go on and you will hear a dial tone. Wait for 5 seconds, then
press the Power button � again to turn OFF the unit.
3. Next, you will be changing the Aura SoHo™ Conference Phone
setting to VoIP mode. The unit should be in On Hook state, which
means no dial tone, and the keypad back light will be off. Press
these keys on the keypad: 1, 0, 1. The keypad backlight will go on
and two tones will sound. Wait about 5 seconds; the keypad light
will go off and then flash once. The unit is now switched over to
VoIP mode and will stay in that setting the next time you turn the
phone on.
4. You can now follow the User Guide instructions for making a
call (page 10).
To change back to Analog Phone line mode
You will need to reset the internal counter again. Press the Power
button �. The keypad back light will go on and you will hear a dial
tone. Wait for 5 seconds, then press the Power button � again to
turn OFF the unit.
The Aura SoHo™ Conference Phone should be in On Hook state,
which means no dial tone, and the keypad back light will be off.
Press these keys on the keypad: 1, 0, 0. The keypad backlight will
go on and two tones will sound. Wait about 5 seconds; the keypad
light will go off and then flash once. The unit is now switched back
to Analog phone line and will stay in that setting the next time
you turn the phone on.