Timex T301 - Manual (Page 8)

Operating the Dual Alarm System
This clock radio features a dual alarm system, with two separate alarms that can be
operated independently. The alarms can be set to wake two people at different times, or
to have a main alarm and a backup. One alarm features your choice of radio stations as
an alarm wake sound, while the second features a buzzer wake sound. You can set the
radio alarm, the buzzer alarm, or both alarms.
Setting Radio Alarm
1. Press the
´ Alarm Set Button. The display will flash and the Radio Alarm Indicator
will appear. If you do not begin setting the time within ten seconds of pressing the
´
Alarm Set Button, the display will stop flashing and you will need to press the
´
Alarm Set Button again.
2. While the display flashes, press the
² Tuning/Set Buttons to set the wake time. Hold
a button for a few seconds to advance the time rapidly. Be sure to set the correct
AM/PM time, as shown by the PM Indicator.
3. After setting the radio alarm time, you will need to select the station to wake up to.
First, press the
º AM/FM Button to select a radio frequency. Next, select a station
using the
¸ Radio Preset Buttons. For more information on programming radio
stations into memory, see the Programming Radio Station Settings section of this
manual. Rotate the
ƺ Volume Thumbwheel to set a wake sound volume level.
4. After setting the radio alarm wake time and sound, you will need to select your 7-5-2
setting. The 7-5-2 setting lets you set the alarm for a full week, weekdays only, or the
weekend. Before setting the alarm, be sure that the correct date is set, as shown in
the “Auto-Set” and Manual Time and Date Settings section of the manual. While the
display is still flashing, press the
¾ Date/7-5-2 Button until the desired setting is shown.
5. After you have set the radio alarm wake time, wake sound, and 7-5-2 setting, press
the
´ Alarm Set Button twice so that the display shows the standard, non-flashing
display.
Setting Buzzer Alarm
1. Press the
´ Alarm Set Button twice. The display will flash and the Buzzer Alarm
Indicator will appear.
2. While the display flashes, press the
² Tuning/Set Buttons to set the wake time, as
described above.
3. After setting the buzzer wake time, use the
¾ Date/7-5-2 Button to select the buzzer
7-5-2 setting, as described above.
4. After you have set the buzzer wake time and 7-5-2 setting, press the
´ Alarm Set
Button once so that the display shows the standard, non-flashing display.
8