Timex T612S - Manual (Page 6)

Unpacking and set up
1. Remove radio and all packing materials from the carton.
2. It is a good idea to save all packing materials in case the unit ever needs to be returned for service. If you do
dispose of the packaging, please do so properly.
3. Remove any feature labels, fact tags, or clear protective films from the front or top of the radio, if applicable. Do
not remove any labels from the back or bottom of the radio.
4. Place the unit on a level surface, close to an AC outlet, out of direct sunlight, and away from source of excess
dust, dirt, heat, water, moisture, vibration, and strong magnetic fields.
5. Do not block the ventilation holes on the back or bottom of the cabinet.
6. Plug the AC cord into an outlet.
Note: Backup battery should be installed before plugging in the AC cord. The clock will start working when the AC
cord is plugged in for the first time. For backup operation, refer to Battery Backup System.
Battery Backup Installation
1. Gently turn the unit over and open the battery compartment door.
2. Install 2 AA batteries, making sure to match the battery polarity (+ and -)
to the diagram in the batteries compartment. We recommend using alkaline
battery for longest dependable life.
3. Close the battery compartment door, turn the unit right side up, and plug
in the AC cord.
Battery Backup System
The backup batteries will maintain the time and alarm settings in the event of a temporary power interruption. If the
power foes out, the CD, nature sounds and radio will not play and no display will be visible but the clock will continue
to run. However, alarms will not sound during power interruption.
If a power failure occurs and backup battery is not installed or dead, all settings will be lost. When the power is
restored the display will read “12:00” and continue to run.
5
Preparation for Use
Battery Compartment
ᕡ
ᕢ
ᕣ