Troy-Bilt 2690 - Manual (Page 9)

Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-7.
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to minimize
combustion chamber deposits) with a minimum of 87 octane.
Gasoline with up to 10% ethanol or 15% MTBE (Methyl Tertiary
Butyl Ether) can be used. Never use an oil/gasoline mixture or
dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank.
DO NOT use E85 gasoline.
Refuel in a well-ventilated area with the engine stopped. •
Do not smoke or allow flames or sparks in the area where
the engine is refueled or where gasoline is stored.
Do not overfill the fuel tank. After refueling, make sure the
•
tank cap is closed properly and securely.
Be careful not to spill fuel when refueling. Spilled fuel or
•
fuel vapor may ignite. If any fuel is spilled, make sure the
area is dry before starting the engine.
Avoid repeated or prolonged contact with skin or
•
breathing of vapor.
Adding Fuel
WARNING! Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
WARNING! Always keep hands and feet clear of
the equipment’s moving parts. Do not use a
pressurized starting fluid. Vapors are flammable.
Clean around the fuel fill before removing the cap to fuel. 1.
A fuel level indicator is located in the fuel tank. Fill the tank 2.
until the fuel reaches the fuel level indictor, Fig. 3-8. Be
careful not to overfill.
Chute Clean-Out Tool
Figure 3-7
Fuel Level Indicator
Top View
Figure 3-8
9 s
ectiOn
2 — a
sseMbly
& s
et
-u
p