Hyundai H-CMD7079 - Manual (Page 32)

32
AUX in, RCA out, SUB out, Video out and USB/SD operations
Auxiliary Input
The Auxiliary input jack is on the front of unit. Use the stereo jack wire and connect to the stereo plug of the unit.
Route the other end of the wire to the any external audio device. Press and hold the MODE button to choose AUX in.
Use VOL knob to adjust volume.
RCA Output
The RCA output jack is on the back of the unit. (Refer to Wiring Diagram) This output is for connecting amplifier,
equalizer, or other audio component that requires a pre-amp out connection. (Red = Right, White = Left) Follow the
manufacturers instructions for the audio component that you are connecting.
Subwoofer Output
The Subwoofer output jack is on the back of the unit, (refer to wiring diagram). This output is for connecting
subwoofer that requires a pre-amp out connection. This is a mono output. Follow the manufacturers instructions for
the audio component that you are connecting. To activate this function, press and hold BND/NP/SUB button.
Video Output
The Video output jack is on the back of the unit (refer to wiring diagram). This output (in yellow) is for connecting
monitor(s). You must connect a monitor for car in order to play this unit in VCD. Consult your dealer for any kinds
of monitors that are suitable to use in car. Press BND/NP/SUB button to choose between PAL and NTSC mode.
USB and SD Card
Insert USB flash drive or SD memory card in corresponding slot on the panel. The unit will automatically detect and
play files. Following file types are supported by the unit: MP3, MP4, DivX, JPG. Press MODE button on the panel
or RC to change current mode. The other operations are the same as in disc operations.