beautypg.com

1 psu interface (j901) – Texas Instruments TAS5066PAG User Manual

Page 14

background image

PSU Interface (J901)

2-2

2.1

PSU Interface (J901)

The TAS5066−5111D6EVM module must be powered from one or two exter-
nal regulated power supplies. High audio performance requires a stabilized
output stage power supply with low ripple voltage and low output impedance.

Note:

The length of power supply cable must be minimized. Increasing length of
PSU cable is equal to increasing the distortion for the amplifier at high output
levels and low frequencies.

Maximum output stage supply voltage depends of the speaker load resist-
ance. Please check the recommended maximum supply voltage in the
TAS5111 datasheet.

Table 2−1. Recommended Power Supplies

Description

Voltage Limitations

(4-

W

Load)

Current

Recommendations

System power supply

15 to 20 V

0.25 A

Output power stage supply

0 to 29.5 V

5.5 A

† The rated current corresponds to 2-channel full scale (70 W each) or 6-channel 1/8 scale (9 W

each), which most likely is adequate for a standard 6-channel amplifier design.

Figure 2−1 shows the recommended TAS5111 power-up sequence. For prop-
er TAS5111 operation the RESET signal must be kept low during power-up.
RESET is pulled low during power-up for 200 ms by the on-board reset genera-
tor (U903).

Figure 2−1. Recommended Power-Up Sequence

>1 ms

System power supply

Output stage power supply

RESET