Toshiba W525 - Manual (Page 19)

19
4 Press the REC button.
" " will appear on the screen
for about 4 seconds and the
REC indicator will light.
Press the PAUSE/STILL button
to avoid recording unwanted
material. Press again or press
the REC button to continue the
recording.
Press the STOP button to stop
recording.
" " will appear on screen for
about 4 seconds.
TO STOP RECORDING
TO STOP RECORDING TEMPORARILY
" " will appear on screen for about 4 seconds and the
REC indicator will blink to continue pause mode.
NOTE: The pause function will be released after 5
minutes to prevent damage to the tape or the
VCR. The VCR will change to the STOP mode.
CH 110
While the VCR is recording, press the TV/VCR selector
button to select the TV position.
The TV/VCR indicator will go off and recording will
continue.
Select the TV channel you want to watch by using the
TV channel selector.
NOTE: Some CATV hookups do not permit viewing one
channel while recording another. See pages 12,13.
RECORDING ONE PROGRAM WHILE
WATCHING ANOTHER
After recording, break off the erase prevention tab if you
do not wish to record over the tape.
Cover the hole with adhesive tape.
Be careful the tape does not extend past the edges of
the cassette housing.
Erase prevention tab
Adhesive tape
TO PREVENT AN ACCIDENTAL
RECORDING
Screwdriver
NOTE: Since the VCR has its own TV tuner, it is not
actually necessary to have the TV turned on in
order to make a recording. Turning on the TV
merely allows confirmation of the proper channel
settings on your VCR.
RECORDING A TV PROGRAM
(Continued...)
3 Press the direct channel selection buttons or the
CHANNEL or button to select the channel to be
recorded.
CH 110
00 : 00 : 00 SP
1-9 Press 0 twice and then 1-9 as required.
Example: To select 2, Press “002”.
10-19 Press 0 first and then the remaining 2 digits in
order from left to right.
Example: Press 012 for “12”.
20-99 Press 2 digits in order.
Example: Press 22 for
“22”.
100-125 Press the 3 digits in
order.
Example: Press 110
for “110”.
TO RECORD AGAIN
2 Press the SP/SLP selector
button to select the desired
tape speed SP or SLP.
The counter and SP or SLP
will appear on the screen for
about 4 seconds.
4F22901A P14-19 11/5/2002, 3:11 19