Connections, Connecting to am / fm antenna, Connecting to speakers – Technicolor - Thomson DPL911VD User Manual

Page 9: If you have poor fm reception

Connections

Connecting to AM / FM antenna

• Connect the supplied AM loop antenna to the AM jack.

Position the loop antenna to receive the clearest sound.

• Connect the supplied FM antenna to the FM jack. Move

the antenna in various direction until the clearest signal
is received.

Note

• Keep the antenna as far away as possible from the TV,

VCR or any radiation source to prevent unwanted noise.

If you have poor FM reception

For better FM reception, use a 75 ohm coaxial cable (not
supplied) to connect the system to an outdoor FM antenna
as shown.

Connecting to Speakers

Connect the supplied speakers ,using the supplied speaker
wires to match the colors of the jacks and speaker wires.

• Connect the supplied speaker wire its corresponding

terminal jacks.

To avoid short-circuiting the speakers

• Short-circuiting of the speakers may damage the system.

To prevent this, make sure to take the following precau-
tions when connecting the speakers.

• Make sure the stripped end of each speaker cord does

not touch another speaker terminal or the stripped end
of another speaker cord.

Note

• Be sure to match the speaker cord correctly.
• For optimal sound performance, use the supplied speakers.
• Do not connect speakers with an impendance lower than

the speakers supplied.

Examples of poor conditions of the speaker cord
• Stripped speaker cord is touching another speaker

terminal.

• Stripped cords are touching each other due to excessive

removal of insulation.

FM 75

Ω

CENTER

RIGHT

LEFT

REAR

Green

Purple

Black

Grey

Black

Red

6 ohm

8 ohm

Black

White

Blue

6 ohms