Toshiba 34HFX85 - Manual (Page 16)

16
Using the
Remote Control
Using the remote control
Preparing the remote control for use
Your Toshiba TV remote control has one dedicated TV mode and five
universal modes: VCR, Cable/SAT, DVD, Audio1, and Audio2.
The target devices and default devices being programmed for each
mode are as follows:
Target device/Mode mapping
Mode
TV
CABLE/SAT
VCR
DVD
AUDIO1
AUDIO2
Device
Toshiba TV
Universal Cable, Satellite
Universal VCR, DVD, LD, Cassette
Universal DVD, VCR, LD, Cassette
Universal Audio: Amp., Tuner, Misc.Audio, CD/MD
Universal Audio: CD/MD, Amp., Tuner, Misc.Audio
Default device codes
Mode
TV
CABLE/SAT
VCR
DVD
AUDIO1
AUDIO2
Default device
Toshiba TV
Toshiba Satellite receiver
Toshiba VCR
Toshiba DVD
Pioneer Audio receiver
Pioneer LD
Repeatedly press MODE to cycle among the modes. If you own
different brands of audio/video devices, you must first program your
remote control (see “Programming the remote control for use with
your audio/video devices” on page 19).
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
2. Install two “AA” size alkaline batteries. Match the + and –
signs on the batteries to the signs on the battery compartment.
3. Slide the battery cover back on to the remote control until the
lock snaps.
MODE
Note:
Your TV’s remote control may not operate
certain features on your VCR, cable TV
converter, or other electronic device.
Refer to the owner’s manuals for your other
devices to determine their available features.
If your TV’s remote control does not operate a
specific feature on a device, use the remote
control that came with the device.
Caution:
• Never throw batteries into a fire.
Notes:
• Be sure to use AA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries
in accordance with applicable laws and regulations.
• If the remote control does not operate correctly,
or if the operating range becomes reduced, replace
batteries with new ones.
• When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
• Always remove batteries from remote control if
they are dead or if the remote control is not to
be used for an extended period of time. This will
prevent battery acid from leaking into the battery
compartment.
J3U00321B(E)_P16-26 9/08/2005, 10:33 AM 16