Toshiba 625012200G - Manual (Page 21)

21 21
Adjusting the Lens
Based on the live image retrieved from the camera, adjust the camera lens by doing the
following:
W
T
8
N
DO NOT overrotate the lens. Doing so will damage the camera lens module.
To adjust the viewing angle -- 3-axis mechanism design
1. Loosen the pan adjustment screw and then turn the lens module left and right. Upon
completion, tighten the screw.
2. Loosen the tilt adjustment screws on both side of the camera and then turn the lens
module up and down. Upon completion, tighten the screws.
3. Loosen the rotation adjustment screw and then turn the lens to adjust the image
orientation. Upon completion, tighten screw.
To adjust the zoom factor and focus range
1. Loosen the zoom controller to adjust the zoom factor. Upon completion, tighten the
zoom controller.
2. Loosen the focus controller to adjust the focus range. Upon completion, tighten the
focus controller.
3
1
2
Loosen
Tighten
Loosen
Tighten
Loosen
Tighten
Loosen
Tighten
Rotate the screw
Turn the lens
Pan 350° Tilt 85° Rotate 350°
The sophisticated 3-axis mechanism design offers very flexible,
easy hardware installation for either ceiling or wall mount.
Do not tighten the tilt adjustment
screws too much by screw driver.
Doing so will damage the tilt
mechanism.