Technicolor - Thomson RS1290 - Manual (Page 10)

CD Player
MIX
PROG.
TIME
PRESET
C D TA P E
STOP
REMAIN
PLAY / PAUSE
REMO T E
SENSOR
PRESET EQ
INTRO
PHONES
BEAT CUT 1 2
MONO STEREO
TU N E R
VOLUME BAND
TUNING / SKIP / SEARCH
COMPACT
DIGITAL AUDIO
CD / CASSETTE / RADIO MICRO SYSTEM
P R E S E T E Q U A L I Z E R S O U N D C O N T R O L
TIMER TIMER
R . D . S.
TUNER DISPLAY
R.D.S
POWER /
ECO
EN
7
Loading and Playing CDs
1. Push lightly to open the CD door. Load a CD
(with labelled side facing up) into the CD
compartment. Then, close the door by pushing
it down lightly.
2. Press CD to select CD mode and the power will
be turned on automatically.
3. Press PLAY/PAUSE to play.
You may:
• skip to other tracks by pressing TUNING/
SKIP/SEARCH.
• press REPEAT 1/ALL once to play a particular
track repeatedly. REPEAT is shown in the
display simultaneously. Press REPEAT 1/ALL
again to play all tracks repeatedly, at the
same time, REPEAT is flashing in the display.
Press REPEAT 1/ALL third time to de-select
the function.
• listen the tracks randomly by pressing
SHUFFLE/MIX.
4. Press STOP to stop playback.
Tip: If the CD compartment is not loaded with a
CD or the CD is unreadable, the message “NO
NO NO NO NO
DISC DISC DISC DISC DISC” will be shown.
Setting Intro Play
Intro Play let you enjoy the CD tracks for 10 seconds.
When the last track has played for 10 seconds, the
Intro Play stops.
1. Follow step 1 and 2 of “Loading and Playing
CDs” above.
2. Press INTRO and the INTRO icon will be
shown.
3. Press PLAY to start playback form the first
track. You may press TUNING/SKIP/SEARCH
to select a particular track.
4. Press INTRO again to exit intro play.
Programming
1. Select CD mode by pressing CD.
2. Press PROG after the CD has been loaded into
the system. The message “00 PRO 1” will be
shown on the display.
3. Press TUNING/SKIP/SEARCH to select a track
to be stored into memory location 1.
4. Press PROG to confirm your selection and
store that track into memory. Repeat step 3
and this step until you have stored enough
tracks or 32 tracks into memory. PROGRAM
keeps flashing when you are setting the
program.
5. Press PLAY/PAUSE to run the preset program.
When the unit is playing the program,
PROGRAM is shown instead of flashing.
6. Press STOP or open the CD compartment door
to clean the stored program.
RS1290
AM1150/AM1155
RS1290 2/16/01, 12:00 PM 11